Cold Air Intake Kit for 2011-2017 Jeep Compass/Patriot 2.0L/2.4L

2011–2017 Jeep Compass and Patriot 2.0L/2.4L Cold Air Intake Kit

Replace the factory intake plumbing with a 3.0-inch aluminum tube, a washable dry filter, and a steel heat shield designed for 2011–2017 Jeep Compass and Patriot 2.0L and 2.4L engines. This Flashark cold air intake kit is built for owners who want a reusable filter and a direct bolt-on intake layout; intake sound, response, and temperature changes depend on the vehicle and driving conditions.

Specifications

Key Features

• Mandrel-bent aluminum tube: The 3.0-inch T-6061 tube has a smooth, consistent routing and a black powder-coated finish.
• Washable dry filter: The red cone filter can be cleaned and reused without adding filter oil. Inspect it sooner in dusty conditions; a typical cleaning interval is approximately 15,000–20,000 miles.
• Steel heat shield: The black shield separates the filter from engine-bay radiant heat. Intake temperature changes of approximately 15–20°F versus stock depend on test conditions and vehicle setup.
• Factory sensor integration: A CNC-machined 3.0-inch MAF housing is intended to maintain a stable airflow signal when the factory sensor is installed correctly; check for leaks and sensor connections after fitting.
• Factory ECU setup: The kit is designed for use without an added tune on the factory ECU. Confirm normal idle and warning-light status after installation.
• Bolt-on hardware: Factory mounting points, a silicone coupler, stainless clamps, and hardware support installation without cutting or drilling; typical installation time is about 60 minutes.
• Expected performance: Approximately 5–10 hp and 6–8% torque change are possible under suitable conditions; results vary with vehicle condition, ECU calibration, installation, and supporting hardware. Throttle response and intake tone may also vary, and fuel economy is influenced heavily by driving habits.

Who This Kit Is For

This kit is for 2011–2017 Jeep Compass and Patriot owners with a 2.0L or 2.4L L4 engine who want a reusable dry-filter intake in place of the factory airbox and intake tube. It suits drivers who prefer a bolt-on design, a more noticeable intake sound under acceleration, and a filter that does not need oil. For other Jeep applications, browse Jeep Cold Air Intake Kits and verify the vehicle listing before ordering.

Check Before Ordering

• Match the year, model, and engine in the Fitment table. This kit does not fit 2007–2010 Compass or Patriot, 2018+ Compass MP/552, Cherokee KL, Grand Cherokee WK2, Renegade, or Wrangler. FWD and 4WD applications are included in the vehicle listing.
• Check the factory sensor and intake connections on your vehicle before installing the 3.0-inch MAF housing and coupler. Transfer the factory sensor carefully and confirm all clamps and fittings are sealed.
• Clean the dry filter as needed; inspect more often after dusty driving. Do not oil it.
• Allow approximately 60 minutes and basic hand tools for a typical installation. Check local emissions rules before ordering, especially in California and other CARB-adopting states.

What's in the Box

• 1 × 3.0-inch mandrel-bent T-6061 aluminum intake tube
• 1 × red washable dry cone air filter
• 1 × black steel heat shield
• 1 × multi-layer silicone coupler
• 3 × stainless steel clamps
• 1 × installation hardware kit

Shipping & Returns