This is a quick and easy way to dress up your vehicle. New upgraded mirror lights give your car a trendy smoked black surface and dynamic LED turn signal light with enhanced safety & visibility at night. In just minutes you can replace the stock orange mirror light with stunning led lights that make your driving intentions better known to other drivers for safe driving.
Applicable Models:
- For Toyota RAV4 XA50 19-20
- For Toyota Alphard 2016-2019 For Toyota Velltire 2016-2019
- For Toyota Highlander XU70 2020
- For Toyota Tacoma N300 2016-2019
- For Lexus LM 2019
High Quality: Side Mirror Lights are made of PC lens and ABS plastic housing with sealed design, waterproof IP65, anti-scratch, no faded with long-time exposure and can adapt to all kind of extreme weather, no moisture inside after heavy rain or car wash.
Sequential Flash: The side mirror light improve the appearance of your car, making your car more fashionable and dynamic. When you use the turn signals, the outside LED side mirror lights will scroll from the center to the side. Give your car a much cleaner look, maximize driver and passenger side illumination.
Easy Installation: Plug and play design, no modification or trimming needed, no additional resistors or relay required. Remove the top shell with the trim tool and 2 screws inside, and then replace the original side mirror turn signals directly.
Install your new light within 10 minutes!
Step 1: Remove the mirror cover with trim tool which can release some of those tabs. (Note: Be sure that the cover doesn’t fall on your driveway and crack or chip the paint.)
Step 2: Remove two screws with a Philips screwdriver to loosen the bracket, and keep the screwdrivers.
Step 3: Unhook the wires from the little hook signified by the left arrow, and depress twp prongs signified by the right arrow to release the pin.
Step 4: Pull the factory turn signals out and depress the connector tab to remove from the light.
Step 5: Connect the new turn signals, slip it into the groove on the bottom of the mirror and install them as factory one. (Note: Mark on the new light “L” for left or driver’s side, “R” for right or passenger side)
Step 6: Put the cover back and test your lights.
Installation video:
https://www.youtube.com/watch?v=GCqluH0uIjo&t=25s